Pages: [1]   Go Down

Author Topic: Fathers Day Pens  (Read 1747 times)

BLKDOGS

  • Guest
Fathers Day Pens
« on: June 17, 2010, 10:03:14 PM »
The pens are for my Father and Father In Law The elm to my FIL and my Dadgets the walnut

There are my 1st 2 pens with a CA finish I would like to thanks all those who gave me some input about how to this finish and for posting the help topics on a CA finish.
These are ther smoothest feeling wood working finish I have evr produced.

Thanks for looking





Logged

Offline jcz

  • New Forum Member
  • *
  • Posts: 3964
  • Age: 46
  • Location: Pinetops ,NC
  • You want some??
    • Trophygamecalls
Re: Fathers Day Pens
« Reply #1 on: June 17, 2010, 10:27:09 PM »
Good looking pens! CA finish is hard to beat on a pen.You did good.
Logged
August Call Makers Throwdown Winner
http://www.trophygamecalls.embarqspace.com/

Offline HaMeR

  • New Forum Member
  • *
  • Posts: 2950
  • Age: 63
  • Location: New Philadelphia, Ohio
    • brightwoodturnings
Re: Fathers Day Pens
« Reply #2 on: June 18, 2010, 10:06:52 PM »
Those look very nice. I think they will go over well for you. I don't see much Elm being turned & I like the looks of it.
Logged
RIP Russ,Blaine,& Darrell!!

Glen

2014-15TBC-- 11

BLKDOGS

  • Guest
Re: Fathers Day Pens
« Reply #3 on: June 19, 2010, 06:50:51 AM »
The guy I bought my lathe from  had made a coffee table out of Elm and the grains look so good. He gave me some scraps of it and I figure I helped my FIL cut and burn a lot of elm he might as well write with some. It did turn out just like I was hoping it would.  Thanks for the comments.
Logged
Pages: [1]   Go Up