Well, did my shipping this morning, and then decided to turn a few calls.
Got me a real pretty piece of stabilized buckeye burl out, drilled it and stuck it on the lathe.
Got it turned down and there was a split 3/4 of the way through the blank from top to bottom.
Drilled a piece of stabilized spated oak, put it on the mandral and it split in half. Hnnnnn
Drilled another piece of stabilized bukey burl, turned it and was getting ready to final sand it. Took it off the mandral. and set up the blind mandral. Slid the call on and the end chipped off.
Just got back from Blockbuster. Rented a couple good movies.
Somedays it pays to take some time off LOL
Al @ THO