The Art of Handcrafting Custom Game Calls > Handcrafting Custom Duck Calls
Shortest drill chuck?
Gary Fisler:
I have a Jet midi lathe with a Nova G3 chuck. I want to drill blanks on the lathe but dimensions are going to be tight. I need a very short drill chuck to make this work. I noticed that Penn State Ind has one with a 1/2 tailstock that looks like it would work.
Any suggestions? What do you use?
FDR:
I use a drill with a #2 Morris taper shank. Fits directly into the Jet tail stock and no chuck is required. The drills are available anywhere machine tools are sold. I get mine from MSC.
Fred
Gary Fisler:
Fred,
Thanks for the reply. I checked MSC and found some taper shanked drill bits. I was looking for brad point but they are not available with tapered shanks. Do you use the standard 118° drill bits?
Gary
FDR:
Yes I use the standard bits. I start the hole by drilling the blank with a center drill first. That gives the big drill a centered spot to start. Tip: Make sure that each end of the blank is square before you start.
https://www.harborfreight.com/center-drill-countersink-set-5-pc-60381.html
https://www.mscdirect.com/product/details/01520402?fromRR=Y
Fred
Gary Fisler:
Thanks. Got the drill bits on order. Will stop by Harbor Freight next week when I'm off graveyard shift for the centering punch.
Navigation
[0] Message Index
[#] Next page
Go to full version