Pages: [1]   Go Down

Author Topic: ? on changing the tone channel length in a insert?  (Read 2851 times)

Offline Jwebb

  • New Forum Member
  • *
  • Posts: 4
? on changing the tone channel length in a insert?
« on: September 09, 2017, 09:40:49 PM »
i drill my tone board on the lathe before i cut the insert. whats the best way to extend it if it needs it after it been cut? ive just been using a drill and sometimes it runs off center when the original is  one channel is perfect.
Logged

Offline James Strickland

  • Administrator
  • New Forum Member
  • *
  • Posts: 1325
  • Age: 49
  • Location: Monroe, LA
    • Bayou Legacy Game Calls
Re: ? on changing the tone channel length in a insert?
« Reply #1 on: September 11, 2017, 10:09:29 AM »
I just use a dremel to extend the length of my tonechannel.
Logged

Offline LagrueCustomCalls

  • New Forum Member
  • *
  • Posts: 229
Re: ? on changing the tone channel length in a insert?
« Reply #2 on: September 14, 2017, 05:28:04 PM »
Like James, I'll extend it with a dremel and proper burr. I only do this on prototypes however, as I can make them run well, but they don't look as 'finished' when I do them like this.
Logged
There's a duck call in that block of wood. I just have to find it!
Pages: [1]   Go Up