Pages: 1 [2]   Go Down

Author Topic: Trouble with call insert  (Read 5971 times)

Offline Moonpiecalls

  • New Forum Member
  • *
  • Posts: 144
Re: Trouble with call insert
« Reply #15 on: October 24, 2014, 10:37:50 AM »
Yea the P2 jig is from pintail.  I found at first with this jig that my biggest issue was how far it was drilled.  That is obviously not my issue this time though. 
Logged

Offline Joe Short

  • New Forum Member
  • *
  • Posts: 651
  • Age: 40
  • Location: Beulaville, NC
Re: Trouble with call insert
« Reply #16 on: October 24, 2014, 03:09:25 PM »
Hah! Disregard my last, Wade's is designated PJ2. Nothing I said will translate between the two.
Logged
"We have a lot of great call makers in NC. Maybe more call makers than ducks." - JCZ

Offline Moonpiecalls

  • New Forum Member
  • *
  • Posts: 144
Re: Trouble with call insert
« Reply #17 on: October 29, 2014, 07:28:28 AM »
Well after finding time to look at it last night for a good few minutes, I see what has gone wrong with this one! HAHA I feel like an idiot for not noticing but I guess when I drilled the end of the ionsert again to bore it out a bit bigger it actually went to far (where the cork goes).  Not sure how I didnt notice this ahead of time, but I think I found my answer.  Lesson learned!
Logged
Pages: 1 [2]   Go Up