THO Game Calls Forums

The Art of Handcrafting Custom Game Calls => Handcrafting Custom Duck Calls => Duck & Goose Call Making Tutorials => Topic started by: Bob from Eames Custom Calls on August 24, 2009, 11:00:28 PM

Title: A short tone channel jig tutorial
Post by: Bob from Eames Custom Calls on August 24, 2009, 11:00:28 PM

I've had a few questions from some of the new faces around here about how to get the end of the tonechannel in the same spot on the jig every time. There's a number of different ways to do this, but I figured I'd show my way real quick to give an example.

These are the pieces I use to set my tonechannel depth in the jig. I reference off of the end of the drilled hole, which gives me the same depth every time.

 (http://i248.photobucket.com/albums/gg194/EamesCustomCalls/tutorials/SANY1595.jpg)

 The pieces are:

 My toneboard jig (a modified version of Wade's public jig)
 A depth gauge from a harbor frieght precision measuring kit
 A 2 1/2" length of 1 1/2" PCV pipe

 I have the depth guage set so that when the guage bottoms out in the tone channel hole, and the PVC pipe stops it, the end of the tonechannel is at the perfect spot on the tone board. Because the insert is referenced off of the end of the tonechannel, no matter how long my insert is, the tonechannel always ends in the correct spot.

(http://i248.photobucket.com/albums/gg194/EamesCustomCalls/tutorials/SANY1596.jpg)

 Here's a link to the measuring kit:

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=94447

 Hope this helps some of you out!

 Best of luck!

 Bob

Title: Re: A short tone channel jig tutorial
Post by: Robert A. on August 27, 2009, 09:21:55 AM

Thank you for the tutorial on this, a very simple yet very effective method.  :bigup:

Title: Re: A short tone channel jig tutorial
Post by: dogcatcher on August 28, 2009, 01:21:36 AM

For those that do not have the depth gauge, I would recommend getting 1 or may 2 or 3 and using them.  They can save a lot headaches.

Marvin

Title: Re: A short tone channel jig tutorial
Post by: stumpjumper on August 28, 2009, 09:18:32 AM

Great post

Thanks
STUMP

Title: Re: A short tone channel jig tutorial
Post by: VECtor Calls on April 20, 2015, 03:04:03 AM

Bump for a good oldie David dug up, headed to the tutorials section.

Title: Re: A short tone channel jig tutorial
Post by: Bob from Eames Custom Calls on April 20, 2015, 12:13:21 PM

Man, I barely remember posting this one.....LOL!

 Bob

Title: Re: A short tone channel jig tutorial
Post by: Jon @ JRwoods on April 24, 2015, 01:35:11 PM

Now the question is ,do you still do it that way?

Title: Re: A short tone channel jig tutorial
Post by: Justin Gwinn on May 14, 2015, 06:34:41 PM

Do you always have the same lenghth exhaust and barrel? if you not and by doing it like this would it make a different sound.