THO Game Calls Forums
The Art of Handcrafting Custom Game Calls => Handcrafting Traditional Reelfoot Duck Calls => Reelfoot Call Making Tutorials => Topic started by: Henry H on July 17, 2013, 12:07:48 AM
-
This way is certainly no better than the others in this section... in fact, it is largely based on a compilation of them. I had different supplies/tools than the others so had to improvise, and thought sharing might spur creative ideas for folks thinking about trying a reelfoot but without some of the tools in prev tutorials.
First, I turn my blanks to 1.25" dowels. Why 1.25? That is how wide my lathe chuck spreads. After deciding on which end will be the exhaust and chucking the opposite end, I mark lines just as FDR does at 1.5" and 2.2" from the outlet. Then I use a 1/4" bit and drill the exhaust to 1.75" (.25" longer than the closest line).
(http://i1285.photobucket.com/albums/a595/HCHpics/SAM_0057_zpsca5fcbed.jpg)
Once drilled, I take the blankd off the lathe and screw it onto my "jig". This jig is a homemade bandsaw sledthat helps with all 3 toneboard cuts. It was made from a leftover wooden section of an incra jig set plus some t-track £ had laying around and a piece of aluminum with a 90 degree angle that came off of something (can't remember what)and sat in abox until this came up. The machine screw end of a 1/4" lag screw fit into that piece of aluminum and is further secured by a nut on the other side. The wood screw end provides the mount to hold the insert. I first cut the length of the toneboard, then the furthest line from the exhaust, then the closest.
(http://i1285.photobucket.com/albums/a595/HCHpics/SAM_0058_zpsb5aa9e18.jpg)
(http://i1285.photobucket.com/albums/a595/HCHpics/SAM_0059_zps6726f3b0.jpg)
(http://i1285.photobucket.com/albums/a595/HCHpics/SAM_0060_zpsd593cc02.jpg)
I end up with this:
(http://i1285.photobucket.com/albums/a595/HCHpics/SAM_0061_zps6501675f.jpg)
Keepung the cutoffs for later, I then move to my drill press to cut the tone channel. I don't have a mill, but found that with a 1/4" mill bit and an xy table, for light work like this one isn't necessary. This is easy to set up and do with a little experimentation and practice. I use a rubber washer under the exhaust end to create a sloped channel. This pic shows it halfway through pass 2.
(http://i1285.photobucket.com/albums/a595/HCHpics/SAM_0064_zpsc757ffc3.jpg)
Once this is done, I'll glue the 3 pieces back together using medium CA (just a couple drops per piece with a newspaper separator to keep it easy to separate them later), the chuck the blank for turning, sanding and finishing.
Hope this helps someone... don't hesitate to ask if I wasn't clear on anything.
-
Slick! Now there is no excuse for you other guy not trying a Reelfoot style call. Thanks for sharing Henry.
Fred